Copy plants

Application

There are two ways to copy plants and here are some things to keep in mind.

End your commands with Enter.

Copy not and Ctrl+ C /Ctrl+ V.

Copy with pressed right mouse button

This is the best way to copy plants in your planning.

  1. Mark the plants that you want to copy.
  2. Pull this with you pressed right mouse button to the desired place.
  3. When you release the mouse button, the command is available, among other things Copy here is available for storage, management and analysis.
  4. Select this command and the plants will be copied to the desired location and im Plant manager created.

COPY command

Do you want a plant however copy multiple times, go the following way.

  1. Select the menu> Group Change the command BILD or give COPY in your command line.
  2. Select the plants to be copied.
  3. Confirm your selection with Enter.
  4. Choose the modus (Single or multiple) and then the Base point.
  5. Place the copies where you want them.
  6. End the command with Enter.

Only when exiting the command with Enter the plants are also in the Plant manager accepted. In this case, use not the key I.

When copying with Ctrl+ C /Ctrl+ V will be save Plant in Plant manager created. Please copy using one of the methods described above.

Further steps